Fabric Covered Wall Panels

(this post contains affiliate links)

Do you have a home office where it would be nice to be able to pin things up on the wall?

Do your kids need a place to display their photos and artwork?

Or maybe you could use a place in your closet to hang up necklaces and earrings?

See how I tried to make a ruched duvet cover for her bed HERE

See how I tried to make a ruched duvet cover for her bed HERE

Then these DIY fabric covered wall panels are for you!


Here’s how we did them:

We used a 4x8 sheet of Soundboard Insulating Sheathing.

soundboard-insulating-sheathing.jpeg


We cut it into 3 pieces — two at 30 x 48 and one at 36 x 48.

Then we primed the front of the Soundboard so the dark board didn’t show through the white fabric we’d be covering it with.

primed-soundboard-piece.jpeg

Then we glued 3/16” thick Masonite to the back of each panel with contact cement. The Masonite is what gives it strength when you screw it to the wall.

Once we had our panels put together, we covered them in a linen-like fabric and stapled it to the back.

fabric-covered-wall-panels.jpeg


We laid out our placement on the wall using a measuring tape, level and painter’s tape to mark exactly where each panel would go. We put the 36” panel in the middle and a 30” panel on each side of it.

placement-of-wall-panels.jpeg

We marked the corners of each panel for our screw placement. Then poked holes through each panel with an awl or ice pick.

screw-hole-in-panel.jpeg

We cut away the fabric on the back around each hole so it didn’t get caught up and snagged by the screws. Then we made the holes just a little bigger with our drill so the screws could go through.

hole-for-screw.jpeg

Using our tape lines as guides, we held the panels up to the wall and marked through each hole onto the wall with a pencil.

We installed wall anchors at each mark where the panels would be attached.

Then we attached the panels to the wall using screws with small washers on the front and screwing them into the anchors. (The washers help keep the screw heads from going right through the soundboard.)

pinboard-wall-panels.jpeg

The last step is to cover the screw heads with fabric covered buttons. I just cut the shank off and hot glued them onto the boards.

diy-pinboard-ideas.jpeg


fabric-covered-wall-panels.jpeg



pinboard-wall-panels.jpeg

Now Loren has a great place to pin up photos, notes, jewelry, cards — anything she wants!


And we don’t have to worry about tape marks or holes all over the walls in her room.

Everybody’s happy!

See the rest of her room HERE


GET THE LOOK

Note: Whenever possible I have listed actual items used. Otherwise I have listed similar products.

As an Amazon Associate, I earn from qualifying purchases